T6CC180

Current Rating 180 Ampere
Phases Three Phase
Firing Mode Current Control
Input Voltage 80-600 Vac
Output Voltage     0-600** Vac
Control Signal  (0-10v) (0-5v) (4-20ma) (5KΩ)
 

**Maximum Output Voltage limited by Input Voltage

 

    

Quantum SCR Phase Angle Current Control SCR are optimized for but not limited to the following fast changing elements/heaters/loads.

If you don't see your application listed please look at our SCR selection guide to help make an informed decision.

Features
Phase Angle Current Control	Adjustable current Limit
1-25 sec adjustable soft-start	Current over protection
Infinite resolution	4~20mA, 1~5VDC, 2~10VDC, 0~20mA, 0~5VDC, 0~10VDC
200~480Vac	Built in fusing
Temperature over protection	Operating Temperature 15F ~120F

Current Control SCR are a type of phase angle suited for quickly changing loads and those with high inrush currents. Certain loads are near zero until heated and must use a special system in order to eliminate blown fuses upon start up. They have an infinite resolution allowing for fine control of quickly changing loads like lamps. There is a higher potential for RF or harmonics but this rarely shows up in applications. Soft starts make this easy on your elements avoiding rapid changes in state greatly increasing longevity.

Use any controller like Watlow and Omega to control your SCR

Our SCR is a direct replacement for any other make SCR, like Omega, Watlow, Johnson and Chromolox

This SCR controls all three hot legs.